Crestron: edit, replace the CSV or delete a configuration

From the Crestron list in Link’nX, you can replace the CSV report of a CI BAOS configuration, rename it, go back over its KNX objects or delete it. The commands offered depend on the creation mode: with a file or with KNX addresses.

Intended for administrators and installers. To create a configuration, follow Add a Crestron configuration.

Before you start

• Open Crestron in the project and gateway concerned.
• Reread the name and the port of the row before choosing it.
• To change the Port, KNX Gateway IP, Gateway port or Gateway physical address of an existing configuration, contact support to establish the steps needed for it to take effect.

Replace the CSV of a configuration created with a file

1. Prepare the new ETS report in CSV for the right device.
2. In the File column, click the small icon with an upward arrow, next to the file name of the row concerned.
3. Choose the CSV. For this replacement, it must not be empty and must not exceed 1 MB, that is 1,000,000 bytes.
4. Reread the browser confirmation Upload file and the chosen name. Confirm to send it, or cancel to keep the current file.
5. Wait for Success!.

Rename a configuration created with a file

1. Click the Edit pencil of its row. The CI BAOS modification form opens and shows To save changes to this device, select its CSV file again.
2. Change Name.
3. Under Upload configuration, select the CSV of the configuration again.
4. Click the floppy disk at the bottom right, then wait for Success!.

Edit a configuration created with KNX addresses

1. Click the Edit pencil of its row. The form displays CI BAOS modification.
2. Change Name or go back over the selection of objects and flags. Check the object numbers after any address removal.
3. Reread the form, click the floppy disk at the bottom right, then wait for Success!.

Delete a configuration

1. Check its uses in the Crestron programming before deleting it. This list offers no restore button.
2. Click the Delete trash can of the row.
3. If a Scenario affected by this change: or Scenarios affected by this change: window appears, examine all the items shown. CANCEL keeps the configuration; DELETE confirms.
4. Otherwise, the browser confirmation asks Supprimer l’élément : nom ? (Delete item: name?), in French in every interface language: check the name before confirming.
5. Wait for Deleted!.

Check the result

• After a replacement, check the file name and the Upload date in the list. The date is hidden if the display is less than 700 pixels wide.
• After an edit, reopen the configuration with Edit and review the name and, in address mode, the matches between objects and addresses.
• After a deletion, check that the row has disappeared. The deletion removes the Link’nX configuration: your Crestron programming stays in place and commands already carried out on the equipment are not undone.

Troubleshooting

• File is empty or File is too large: choose a CSV that contains data and does not exceed 1 MB.
• If the expected name or date is not confirmed after a replacement, contact support before sending again.
• Do not delete and then recreate a configuration to try to correct a connection without a validated procedure.

For other symptoms, follow the Crestron troubleshooting. If a deletion was made by mistake, if you do not know its uses or if the result remains uncertain, contact support@can-nx.com with the context, the name concerned and the message.