Temperature setpoints and ionization thresholds of an Airzone action

In a Link’nX Airzone action, the temperature setpoint and air ionization threshold commands expect a numeric Value. Enter it within the ranges below, in degrees Celsius for temperatures, keeping the low threshold below the high threshold.

Intended for installers and administrators who prepare an action for Airzone zones.

Before you start

• Have the installer confirm, for each selected zone, the available functions, the unit, the limits and the setting step. The ranges in this guide do not replace the installation’s own limits.
• For ionization thresholds, have values established for the equipment.

Set a temperature setpoint

This procedure concerns equipment confirmed in degrees Celsius.

1. In Airzone device, choose the relevant zones. Check that they all use the Celsius unit and accept the planned setpoint.
2. In Airzone command, choose the setpoint to set using the table below.
3. Fill in Value within the indicated range. Also respect the more restrictive limits and the step of your equipment. Fictitious example: 21 for a zone that accepts 21 °C.
4. If the scenario must also change the mode, prepare a Mode selection action and check the order of the actions. A heating or cooling setpoint only sets the corresponding setpoint, without choosing the mode.
5. Reread the value and the zones, then click the floppy disk at the bottom right.

Command	Setpoint set	Range to respect
Temperature setpoint	Setpoint of the current mode	Between 15 and 30 °C
Heating mode temperature setpoint	Heating setpoint	Between 15 and 30 °C
Cooling mode temperature setpoint	Cooling setpoint	Between 18 and 30 °C

Set the air ionization thresholds

Always keep the low threshold strictly below the high threshold.

1. In Airzone command, choose Low air ionization threshold or High air ionization threshold.
2. Fill in Value with a whole number validated for your installation: from 0 to 30 for the low threshold, from 1 to 30 for the high threshold, with the low threshold below the high one. For a threshold above 30, contact support to establish the appropriate entry.
3. Before changing a threshold, check the other threshold and the expected effects with the installer. If both thresholds must change, have the order that maintains their relationship at each step confirmed; do not infer their current values from the action form.
4. Save with the floppy disk.

Check the result

Wait for Success!, or Updated! after a confirmed change, then check where the action is used in scenarios. After the scenario runs, check on the equipment that the setpoint or threshold has been applied: saving does not measure air quality.

Troubleshooting

• After a change of command, re-enter Value.
• If your equipment uses degrees Fahrenheit, if the unit is unknown or if a value outside these ranges is needed, ask support for the appropriate procedure. Do not enter a converted value without having the unit expected by the installation confirmed.
• If the interface refuses a value that is nevertheless established for the installation, if the limits or the other threshold are unknown, or if the command remains without effect, contact support@can-nx.com with the context, the command, the message and the steps already performed.